Anycubic Photon Printer Owners 造訪社團 » 用戶發文

My daughter wants me to print her a jaguar ring to wear. Post curing and painting, i will coat it with a gloss spray. Would that be enough protection on the skin to prevent resin absorption? Most of the stuff I print is for models that don't get much handling so I don't know what I should do for items that have long contact with bare skin.

翻譯年糕

Has anyone tried the plant based resin from Anycubic? https://www.anycubic.com/collections/uv-resin/products/anycubic-plant-based-uv-resin 翻譯年糕

I've had my Photon since July 18 and it's been printing very good since then. That is until yesterday when I started a print, it went through the normal cycles and then just froze at 1%. It didn't do anything just froze. Fan was on, I can only assume the LED was off and only the skid of my print was forming. It's now happened 3 times out of about 8 prints that I've done. Any idea why it's doing this? Crappy power supply? I'm slicing with ChituBox 64bit V 1.3.

翻譯年糕

Ok, I'm new to ChituBox for Photon. What are the proper settings for the "Light Off Delay" and "Bottom Light Off Delay"?

I usually use Monocure Rapid Gunmetal and it would be 8 sec light off in the old Chitu software. No idea? 8 and 8? 8 and 0? or 0 and 8?

翻譯年糕

I checked the Google Sheet for a profile for Monocure Rapid Gunmetal at .01mm but there isn't. Can someone share their experience with Gunmetal at .01mm? Thanks! What is the ideal setting for this color/resin to start with?

翻譯年糕

Chitubox - is out and FREE! This is the successor to Chitu slicer.

翻譯年糕

Has anyone encountered a Photon reboot mid-print? I started a print and heard the printer literally shut off and restart. I raised the plate and it was printing and cleaned off the first few layers and then power cycled it. It was fine afterwards. Is this due to the cheap power supply? What's are people using as power supplies?

翻譯年糕

I remixed a VAT lid for the Photon so it can just lay on top of the VAT and not use the thumb screws which would force a re-level.

翻譯年糕

I have an issue with my z-height setting. When I level the plate against the LCD and try to save this as the z=0 height, the dialog pops up on screen but when I touch YES, it does nothing. SHould it do something? How do I confirm the proper z-height when I start a print? Just hit print and it will automatically go to z=0 and then start? Hitting HOME I believe is the home height but NOT the z=0 height.

翻譯年糕

Does anyone have a resin profile for Makerjuice G+ Fast Gray? I bought this a little while ago but never used it. New in bottle and stored in cool dry room.

翻譯年糕