Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Here I have two Ho scale welding carts. One is printed in Anycubic gray resin and the other in Anycubic green resin. Note one cart is taller then the other and one cart has tiny wheels under it and the other has seemingly lost its wheels. Also note one cart is taller then the other. What can cause this?

翻譯年糕

I seem to have gotten my self in a jam here. I was replacing the LCD screen and the one I ordered did not come with the top glass. Is there any place I can get a glass plate for it? The original did not survive the removal process.

翻譯年糕

I'm having a strange problem. I get resin cured to the FEP film where Parts are NOT located. It prints parts fine, but I have to clean the FEP / Vat after every print. I'm using Anycubic White resin. My printer settings are: Layer thickness: 0.035 normal exposure time: 14 off time: 1 bottom exposure: 65 and bottom layers: 8

Thank you for your help and your time.

翻譯年糕

For those of you who use Ultrasonic Cleaners, how long do you leave the parts in it for? For those of you who use Ultrasonic Cleaners, how long do you leave the parts in it for? 翻譯年糕

I'm getting some peeling on the last layer. Any ideas? Thanks. I'm getting some peeling on the last layer. Any ideas? Thanks. 翻譯年糕

I'm having some trouble with curing parts. I'm using Anycubic Gray 405nm and I have my exp. time up to 25 and still after a good rinse and scrub then in the UV chamber for an hour and some parts are still tacky in places. Is this normal? Thanks for the help. :)

翻譯年糕

Dose any have or can any one point me to the settings and cure time for anycubic 450 nm GRAY. Thanks so much. :) Dose any have or can any one point me to the settings and cure time for anycubic 450 nm GRAY. Thanks so much. :) 翻譯年糕

Can any one tell me what made this happen?

翻譯年糕

So I either left my parts in the wash to long or cured them to long. They warped a bit. These are really small so I was wondering what you all thought?

翻譯年糕

With the Anycubic resin, what glue should I use to glue a resin part to a resin part? So this next line is an Edmonton to the post. I'm selling model kits and they must be glued together. Passing out UV lights and resin would be slightly expensive.

翻譯年糕