Anycubic Photon Printer Owners 造訪社團

Well here goes attempt No. 2. It turned on this time, so we're off to a good start...

翻譯年糕

Hello guys, I was wondering if any of you have checked the total consumption of the printer per hour. I would do it myself but I don't have the tools needed and I thought maybe someone already did here

翻譯年糕

I'm using the green anycubic resin and I was wonder if you wanted to paint something you printed what paint do you guys use? do you prime first?

翻譯年糕

1st print starting. So nervous!

翻譯年糕

Anybody have recommendation for a support software in VR? Anybody have recommendation for a support software in VR? 翻譯年糕

A link in my opinion very useful, at least from which to leave for newbies.

翻譯年糕

Any thoughts on whether this distortion from too few supports, or improper exposure?

翻譯年糕

I live in a studio so the fumes from the printer are a bit more of an issue - I don't really have anywhere else to put my printer.

I mostly run it with my balcony door wide open and a fan, and only when I'm at work, but still gives me headaches sometimes on the weekends (and worried about my dog ? )

I know people have built containers/covers to keep out UV light before the photon used the yellow panes, I'm wondering if making a container out of HEPA filters would reduce/contain the smell, or if the particles are too small? Has anyone tried anything similar? If not I might give it a go and report back on results.

翻譯年糕

2nd compleyed print out of 5 attempts. Detail at 50 micron is lovely. However please help me hone things. I know the bottom of the wagon might be too thin OR need additional supports as it has warped badly in places.

Aside from that there are a few random holes (air bubbles?) but the big issue is there are horizontal and diagonal lines going through the model. I printed it at 10 degree angle so the lines are really 90 degrees I guess.

I have blasted the model in a thin mist of primer and gently scratched the planks with a fibre glass brush to make the errors obvious.

Please help as I want to be able to sell things on this printer but I need the quality.

翻譯年糕

Hi guys I have a question, I'm gonna buy a resin 3d printer and I have two options the wanhao replicator 7 v1.5 with dbox with a few prints on her and a brand new anycubic photon, they both are nearly the same price, which one do you recommend?

翻譯年糕