Anycubic Photon Printer Owners 造訪社團

Fun alien sculpt based of a sketch by William b hand .
Beta LCD @ .05mm @ 9sec. Primed with Rustoleum Chalk FX,

翻譯年糕

Did anyone else buy a resin printer and is to scared to use it because of the fumes, or am I the only one?

翻譯年糕

A small Singing Adalinda dragon printed on 0,025 mm layer, without a supports.
https://youtu.be/oCdwGidh_q0

翻譯年糕

I started the test print about 10 min after opening the box. I’m impressed that a $470 printer produced this result with so little effort. Even the post processing was way less hassle than everybody implied. I think this is the beginning of a beautiful friendship.

翻譯年糕

Can anyone tell me why my first two prints came out smooshed like this? These are supposed to be a test cube and a tank. I used the scale feature in the Anycubic slicer to shrink them, and I had all 3 axis locked to scale the same amount. Is this software or hardware related?

翻譯年糕

Hi. I have a problem. Recent prints do not stick to the middle side of the bed only to the far side. Each time I try to print only those far side prints are ok and all closer to the middle are in the resin tank as flat spots or not printed at all. The FEP film have a small scratch at the middle (only like 5mm) is this can be a reason?

翻譯年糕

Hello fellow photon, I have a problem with printing, everything goes fine until a beeping sound is heard and the motor stops, the platform stops moving, nothing more is heard than the fan and the screen keeps throwing layers, but the motor It does not make noise.
I have tried other impressions and I have the problem again, does anyone know what my problem is?
Thanks in advance.

Well, after changing the pendrive and 11 hours of printing I find that it has failed again.
In the photo are the details, the printing has finished but the platform stopped more or less in 75% but the exposure continued until 100%. Then I pressed the button and with the buttons on the screen I made the platform go to the end without problems, the screw I move it without difficulty.
I'm going to contact the technical service of anycubic so they can send me version 4.2.5 to see if it is the solution.

The problems continue ...
I have changed the power supply
I have tried doing the vacuum printing without vat and without platform
I have put the firmware version before the update

I'm still waiting for an answer from the Anycubic service

Thanks to the technical service ... the problem has already been solved.
They sent me version 4.2.5, formatted in fat32 without being fast and I copied the files to the pendrive and to print to full.

翻譯年糕

Mi consigliate un buon primer è uno stucco riempitivo?

Lo stucco mi servirebbe per livellare lo spigolo di una base rotonda che ha una piccola rientranza si parla di qualche millimetro di “buco” (allego foto) potrebbe andare bene o devo ristampare? Grazie

翻譯年糕

my latest model is now live. hope you like it.

翻譯年糕

Anyone tried making lithophanes on their photon? Anyone tried making lithophanes on their photon? 翻譯年糕