Anycubic Photon Printer Owners 造訪社團

Ring football club "Spartak Moscow"
Resin anycubic maroon

翻譯年糕

Miniature i modeled myself. I am happy with the result. Except the support marks on the back. Will experiment with orientation while printing to fix that.

翻譯年糕

A quick question from the novice. I have some miniatures to print (size around 36mm). I’m using Anycubic green resin that came with the printer. What are the best setting and posing for such prints and what resin is the best for such miniatures? My current attempt was at 45-degree light autosupport plus some additional supports, print settings 04, 8, 3, 55, 9. I had some problem with heads (print less details then on the rest of the body). Should I use 03 or 02 thickness instead of 04?

翻譯年糕

Am I trying to print too thin ? Or should I try printing at an angle ?

翻譯年糕

Has anyone else encountered a thin film of cured Resin that covers the entire build plate after a print? It seems like the print is turning out OK but that film is annoying.

Monocure rapid black 0.05mm layers. 12/1.5/60/8. It's almost as if the whole lcd is leaking enough UV to cure the whole build area slowly. This was not occurring with fun2do industrial black but I also recently swapped out the fep sheet.

翻譯年糕

A quick question about resin exposure time calibration tool:
does anyone have .photon files to check with a small step? For eg from 11 to 20 with 1s step or from 10.5 to 15 with 0.5s step? I haven’t seen any around but will create if no-one knows where to find them.

翻譯年糕

Looking for some help figuring this out...all the sudden I am getting some crud appearing on my prints after the UV light. My process after printing has been, Sonic bath in 99% alcohol, quick water bath to remove alcohol, then about 30mins under UV light then finally a quick wash with soap and water. Been working ok but now this? Any ideas? Thanks in advance.

翻譯年糕

Hi everyone,
Planning to buy this amazing printer to create buttons/switches and the rotary switches to create my own panel for a flight simulator.
I have an AM8, but this one is perfect for small print.

翻譯年糕

Again NO print, LEFT SIDE : what was stuck t the bottom of the vat and RIGHT SIDE : what was on the print plate...
Did new calibration before printing because of installation new LCD.
Maybe calibration was too “loose”? (Last time it was too “tight”)Or what do you guys think??? Thank you!! Philippe have you got the solution?

翻譯年糕

So I have an issue with part orientation. is their an option to place a object face on the bed. second is there a way to set the height at which it prints at meaning longer supports (to let the resin flow away from part and not pool and cure). for some reason when I generate supports they look great and long but when i go to slice it makes them way short. over all the print came out great other then two edges.

翻譯年糕