Anycubic Photon Printer Owners 造訪社團

原文網址 Anthony Roach Jr.
2018-09-10 02:43:02

Hey guys, first time on here. Just got my printer about a week or so ago, did a few prints no problem. Now i had my first fail, and i noticed these bumps... Is it time to change the film?

翻譯年糕

原文網址 Zac Morris
2018-09-10 01:35:28

Antlers made up in Rhino/Zbrush and printed in Nova3D resin.

翻譯年糕

原文網址 James Darknell
2018-09-10 01:13:29

Hi all, just joined the group. I'm interested in the printer, but the only place I have space for it is in the garage, where operating temps would vary widely throughout the year, as low as 40f to upwards of 100f in the summer (5c - 37c). I'd say avg. though is around 65-75f. Is this a workable situation? Anyone in a similar boat??

翻譯年糕

原文網址 Stefan Lukus
2018-09-10 01:10:33

So I set up my printer, install software, and open photon slicer but i have no "test" file...

翻譯年糕

原文網址 Sandro Montecchiani
2018-09-10 01:00:37

Hi Photonsters, a question about the Nema 17 Photon stepper motor: how long is the lead screw ? I ordered via AliExpress a replacement motor for Photon, but the one arrived have a too long screw more than the one inside the printer....

翻譯年糕

原文網址 Страцимир Алексиев
2018-09-10 00:02:30

Anycubic Photon test 1-2: Layer 0.02; NormalET 7,5; OffTime 1,5; BottomExp. 40; BottomLayer 8

翻譯年糕

原文網址 Alison Friedlander
2018-09-09 23:49:06

I saw a few people mention using natural rubber for their molds and/or that silicone would warp the resin from the anycubic. Does anyone have experience with this?

My plan was to get an anycubic in the next few weeks so I could make in-house masters for assorted small objects that I'd cast multiples of later, but I was planning on using silicone for those molds. I'm wondering if I need to rethink those plans. Thanks!

翻譯年糕

原文網址 Frank Kincell
2018-09-09 23:15:05

I've had the Photon four days and printed 7 things. No failures. Amazing printer. Wish I had bought it earlier.

翻譯年糕

原文網址 Julia von Pfaler
2018-09-09 21:55:50

Testing with FTD-industrial red. Print looks ok, 0,05; used 12 as a normal layer. Height from the bail to the paw is 28mm. The red smells just as much as the green resin does, but at least it's not any worse. I'm going to be making a vulcanized mold tomorrow and see how well it keeps it's shape. With Anicubic green, the print deformed if silicone was used, so had to use natural rubber instead...such a stinky stuff. Surrounded by stinky things ? I'll recreate the test and start with silicone and hope it works.

翻譯年糕