Anycubic Photon Printer Owners 造訪社團

Hey Everyone! Ive had a few epic prints but have noticed that on my last print the build plate has moved mid print. Is this due to Z wobble?

Thanks :)

翻譯年糕

Has anyone found a solution to quieten the z axis like a stepper dampener? The fans don’t bother me nearly as much as hearing the build plate go up and down :)

翻譯年糕

Beware the Orc
75mm
Resin phrozen 9.5s @ .05
https://www.myminifactory.com/…/3d-print-high-overlord-varo…

翻譯年糕

Monoprice Rapid Resin Gray is kind of terrible. Couldn't even get the exposure test to work until the 4th try and even then the pigment would not stay mixed even though I mixed it for about 5 minutes, and the earliest exposure it responded to was 24 seconds and there were no useful exposures until at least 36 seconds. I'd say steer clear of it. I'm sticking to Monocure, Anycubic, and Nova3D

翻譯年糕

Hi guys
So i have sucessfully printed the testcube that came on the stick.
Does one have a screenshot of exact those settings that were used to slice that?

翻譯年糕

Any coupon codes for makermarket.co?

翻譯年糕

Magneto coming along. The cape is fdm and sucks big time but I don’t care. Still the best cape that came out. Magneto is beautiful off the photon.
Darkened the purp a bit. Going back for highlights later

翻譯年糕

One step further to get rid of the smell.
https://www.thingiverse.com/thing:3080876

翻譯年糕

Warming my hands up in the morning, taking another crack at casting wanhao black..

翻譯年糕

Now I was printing models successfully but now nothing is sticking to the plate. It started mid way through a bottle of cubic Green with settings
layer 0.05
normal 15
off 6.5
bottom exposure 80
bottom layer 8

I have cleaned the plate after each job and due to the failed print in the resin tray I have re-cleaned the tray after each failure. I have also re-leveld the plate and still it has failed.

Should I sand my plate or is there something else to do before I go to that irreversible step?

翻譯年糕