Anycubic Photon Printer Owners 造訪社團

So I either left my parts in the wash to long or cured them to long. They warped a bit. These are really small so I was wondering what you all thought?

翻譯年糕

Z=0 not working?

Am struggling with getting prints to stick to the build plate. I have cleaned everything and re-leveled 10 times using the paper method. However I now think that z=0 is not working. I level so the paper is tight, tighten the build plate press yes after z=0 then raise the build plate.
When I then press home again it goes down and the paper is now loose again?
Any tips?

翻譯年糕

Ok im on my knees begging you all.Pulled nearly all my hair out. And mrs ready to leave me.Every print apart from the cubes comes out squashed and distorted.please any help would save my sanity.1st image what it shoul be.2nd what i finish up with. Thanks in advance.

翻譯年糕

Guys... what setting use for orange anycubic resin? Bottom 50, layer 8..... with this setting red and green is ok thx

翻譯年糕

My yesterday and night printings. Resin 3D Okay White. Settings: layer 0,04; normal exposure time 12; off time 1; bottom exposure 60; bottom layer 8. Files from thingiverse. There are in heart some unexpected holes. Heart was printed about 9 hours (Anyphoton slicer told that will be printed less than 7 hours). Small figure is cleaned IPA, so is not glossy.

www.thingiverse.com/make:533194

翻譯年糕

Printed a 3d scanned model of Platon @ 0.05 mm

翻譯年糕

Which 3D modeling software do you use?
I am trying to choose between zbrush core and blender.

翻譯年糕

My first completed 3d printed model

翻譯年糕

I've been having some trouble lately where my print will start, and then after the first several layers it will crash and restart. Any thoughts?

翻譯年糕

Can someone post their settings for X, Y, and Z size in Anycubic Photon Slicer?

My settings are:

翻譯年糕