Anycubic Photon Printer Owners 造訪社團

Anyone know what happened to this print?

翻譯年糕

Hi guys. Failed test print. At 82% I checked and noticed my support around the chin area for the big head was not sticking into the plate and was hanging and warped so the chin and mouth area deformed. I then had to cancel. I used 15% auto support. Will cure and prime tomorrow. Will also try to print the missing part of the head. Cheers!

翻譯年糕

Hello everyone I have a question to be submitted: the two screws in the picture are declared 8mm diameter and 2mm lead / pitch, but they are clearly different, the left is the classic that mount all the prusa instead the right one and mounted on an photon .
can you tell me what the difference is?

Where can I order the single nut without the motor?
thank you in advance

翻譯年糕

what kind of filter do you normally use when you put the resin back into a container? The printer itself comes with 5 coffee-filter like filters, but what are cheap and okay to use?

翻譯年糕

So, it has been far too long since I have been able to print. I am finally all moved, have the Photon unboxed, and I am trying to dial in my new Bucktown resin. All seems well until I hit the 5 box calibration model I designed. Suddenly, the center cube will not print. So I up the time. Still doesn't print. I up it again, now all the text has disappeared (overcuring). I clean the machine up and put in the Nova3d resin I was using before I shut down. re-use it's original model and it does the same thing. I am noticing a slight whitening of the FEP film, so I am going to try to change that. Wish me good luck!

翻譯年糕

Am i killing this model with supports? Far too many I'm guessing. I'm still learning what i can get away with

翻譯年糕

hi all broke my screen and the glass under it trying to clean a mark off, the glass i could get easily but the display i need to order and am not sure i am buying the right park, can someone check for me thanks, cant find it in any docs on the page.

翻譯年糕

Just finished my entry to the # monocomp4 contest. I printed this on my Photon using Monocure rapid white resin. My settings were 0.05,12,110,13 I really with i would have printed him a little larger as I'm not as good at painting detail as i used to be. :)

翻譯年糕

At my wit's end with this machine. My initial prints were great but now, everything peels off the plate. I've increased exposure time and sanded the plate and I'm using Anycubic resin. Any other ideas I haven't tried?

翻譯年糕

Anyone know if there's .photon file repositories anywhere? Ones that people have run already themselves and know they work well. Would be cool to see what people have done

翻譯年糕