Anycubic Photon Printer Owners 造訪社團

Guys, which resin is the best for straight hot rubber mould preparation?? Thank you)))

翻譯年糕

Sharing 5u test results for Anycubic grey resin. Just off the plate. I'll be trying in the 8-10 second sweet spot.

翻譯年糕

Its very exiting, I'm almost ready for my first print. Today I build the enclosure for my Anycubic Photon and the next thing to do is to do the first print.

Se the enclosure here.

翻譯年糕

Hi, we all learn from our mistake... I just started using Resinaway. Work very well. So well, the cover of my sonic cleaner is melting too !

翻譯年糕

Hi. What slicing parametrs do you use for castable senertek resin for jewelery in your photon? My first print failed with default parameters from senertek supplier.

翻譯年糕

Apparently some resin got under my vat and dried on the 2k screen. It's not terrible, but I wanna get it cleaned. What's the best way? I assume using the scraper on it is not a good idea.

翻譯年糕

Once the model is cured and off the supports, will it give a fair representation of how much resin I have used it i weigh it? Or does the mass change during printing and curing?

翻譯年糕

Hi. What parameters do you use for castable senertek resin for jewelery in your photon? My first print failed with default parameters from senertek supplier.

翻譯年糕

This model have some errors and i did not ran it into NetFabb, cloth flake out on the legs. Model looks very good.
Monocure Flex25
50 microns.
11sec, 1sec off, 80sec bottom, 6 layers.

翻譯年糕

Gentlemen: I would lime to seek advice for a friend who has been having the most difficult time printing the handrails of a 1:32 staircase. The handrails “shrivel up” a bit. Support diagram and settings as pictures (8 secs per layer). Other less challenging prints (boxes and cones for example) usually turn out fine. Thanks in advance!

翻譯年糕