Anycubic Photon Printer Owners 造訪社團

What’s the best/cheapest way to ventilate the printer fumes?

翻譯年糕

Thought I would post a quality comparison. Reprinted my mini for pathfinder. The detail from resin is unparalleled. I used as fine of detail as I could on the FDM (0.25mm nozzle with 0.04mm layer height and a slooow speed), I also split the FDM model up to minimize supports. I feel that is the best quality I can get after months of testing. Whereas with my Photon it was sooo simple.

翻譯年糕

What's your layer curing time for the included green resin? What's your layer curing time for the included green resin? 翻譯年糕

Hi all, had some prints fail on me so decided to give me printer a full clean and re level when I noticed this, any idea what it is and if I can fix it, its not on the surface as I gave it a good wipe

翻譯年糕

Hi thanks for adding me! I just want to ask something weird. A friend of mine just got the anycubic photon to make dolls. The "problem" is that the pixels of the masking screen that cures the resin are visible on some curved areas. Now that is easily sandable but... what if we could make those more faded? I thought about using a thin translucent film on top of the 2K screen to lightly diffuse the pixels and the light to make the hard edges of those pixels less sharp and make the finishing process easier. Now please, could you tell me how stupid of an idea this could be? seriously it kinda works in my head... but maybe some experienced users have something to say. thanks.

翻譯年糕

I am in touch with a China supplier for the LCD screen. I can get 25 units shipped to the untied States for 410$ total. Is anyone interested in a group buy?

翻譯年糕

Do i need to calibrate Z Homepoint again after Firmware-Update?

翻譯年糕

Question for anyone using "rain x" on the fep sheet, have you noticed any real improvements, also are you using the original "rain x" or "rain x for plastic"?

翻譯年糕

Uh ive made a bit of a mistake with a print and forgotten to add supports /raft and now i dont know how to remove it... HELP!!!!

翻譯年糕

Well, the good news is that my first print went well as far as the printer was concerned. I approached this with a certain amount of trepidation after my disastorous experience with the XYZ Nobel but I needn't have worried. The print quality was excellent but I obviously have a lot to learn about supports - something I rarely used in FDM as I tended to make everythying like an Airfix kit. One side of the bus lower deck (which measures 58mm long) is fine apart from a few minor burrs from the removed supports, but as you can see the supports have actually fused to the side in the other picture. I've added a screenshot of the auto support (full) and ringed the offending area. I tilted the X 50' but left the Y and Z at 0' - would I have been better tilting the Y by say 10', which seems to alleviate the need for a lot of the auto supports. I also lifted it off the bed by 2mm and added a couple of supports round the base. Looking at the pre-sliced picture I can see that the ringed area supports were very, very close to the body so I guess I should have deleted them and added new ones. I used medium support by could probably have got away with light. Any thoughts from anyone gratefully received - but I am very pleased so far with the quality!

翻譯年糕