Anycubic Photon Printer Owners 造訪社團

For people using bluecast ,what setting are you using I have had several failed prints . Plate is sanded down I think its my settings

翻譯年糕

Might be a stupid idea, but has anyone tried to print a clear vat so you can see whats going on in there? Could print on FDM and cast in clear. Killing me that I can't watch the first few hours of a print

翻譯年糕

Getting quit a few issues with my printing lately and getting issues like this, any idea what's causing it?

翻譯年糕

Well this happend to me today. Exactly 50% of the modell is missing. I did a screen test and it also showed just 50%. After a restart,the screen test worked again and i just restarted the print. :/

What causes this? Is there a fix?

翻譯年糕

which settings are best for Anycubic clear resin? which settings are best for Anycubic clear resin? 翻譯年糕

Yee Boyss!

How do I change the support columns from solid single beams to connected crisscrossing scaffolding? Thanks again for the rookie support! How do I change the support columns from solid single beams to connected crisscrossing scaffolding? Thanks again for the rookie support! 翻譯年糕

I have delayed the inevitable for as long as I could - didn’t want to print the default test print ? but here it is - printed with a concoction of 99% Nova3D blue 1% Photocentric flex clear and a tiny touch of urethane yellow dye to give a bit of green tint

翻譯年糕

My print fails. The support gets pulled off after some time. Do I have to sand down my plate?

翻譯年糕

Any idea what caused this melted look?

翻譯年糕