Anycubic Photon Printer Owners 造訪社團

Delete if the question is off topic , but I am looking to buy the anycubic photon dlp resin printer. Can i print any 3d model stl with a resin printer ? O noticed gambody models in general have fdm/ sla models but never seen a dlp models

Appoloigse if it's a dumb question

翻譯年糕

Bam! Holes AND hollow! I’m a pro now! Now I need to file and glue the horns! Body at .02 and horns at the mystical .01!

翻譯年糕

Continues to amaze. A couple later issues and a little shift in one of the arms though. Not sure what's going on.

翻譯年糕

?

Does anyone have any reference material to the board on this? (before i take it apart), id like to interface my own esxternal display to it for a few nefarious reasons (serial display, so only need a com or network port to poll) want to use one of these display on it hooked to some omron's i have laying about to do better homing and read out actual Z motion etc

翻譯年糕

Hellboy drying out

翻譯年糕

I total lost the plot now with it don't know what to do think it time to throw in the towel and call it a day with resin printing I total lost the plot now with it don't know what to do think it time to throw in the towel and call it a day with resin printing 翻譯年糕

Hi all,are you all using specific cleaning stations Hi all,are you all using specific cleaning stations 翻譯年糕

Hello. I'm printing miniatures with monocure rapid gunmetal gray. Models are coming out very nicely except for the bases. The bases are cracking and warping as they cure. The models are hollow. Washed out with isopropryl alcohol. Two drainage holes on the bottom. Settings are .05, 8,8,60,5 Has anyone else had this problem? Known fixes? Setting tweak? Any ideas greatly appreciated.

翻譯年糕

Guys, just to be sure:
Second gen Photon only means yellow panels, right?

翻譯年糕