Anycubic Photon Printer Owners 造訪社團

Hello! I'm creating a 3d models of jewelry. Maybe someone will be interested in my shop 3d models. They are perfect for printing on the Anycubic Foton. Thank you!

翻譯年糕

Behold! The humble silicon brush! For less then $2 you too can have a scratch free FEP when stirring your resins and fishing out chunky floaters. I trimmed it down so theres less resin stuck to the bristles, clean with IPA after use. Enjoy!

翻譯年糕

Hello everyone !
I need your advice =)
When printing with a polymer (Wanhao Orange), there were such problems (in the photo)
Printing options: 0.020/10/2/60/8
noticeable steps through large gaps, led the whole model, one of the models fell off the supports in the bath, the support is more fragile than that of Anycubic Green
What did I do wrong?

翻譯年糕

Put photo to the test again. # reimscathedral # cathedral

翻譯年糕

I hear people about the prints not sticking to the bed but at my photon they stuck really well, hard to get off is there a way to make a little 45degrees notch on the bottom off the print to get the scraper between the print and the printbed.. using the original resin that came with the printer printbed cleaned with ipa before the print...

翻譯年糕

My photon has screen issues (happened not long after I got it). Now they want to send me a new screen, but they want me to pay US $10 to cover the postage. I would've thought if it's broken, they'd have to cover that. What have other people's experiences been with replacement parts?

翻譯年糕

These should be ok for the photon?

翻譯年糕

Hi guys.Yesterday my photon arrives.I didnt make any print yet because my printer arrived semi-defected and im speaking with support now.

As you can see in pictures the fep surface is full of scratches and has 4-5 big marks.
Also the screen has a big black spot on left when i test it from menu.And some scratches on the right side.

The support in his first reply told that is not a problem and to print this way.Do you sound this normal?
The printer bought from official anycubic ali store.

Thank you all in advance.

翻譯年糕

Hi there group. Looking for 1st 3d printer to purchase..advice/suggestions pls...cheers

翻譯年糕

Second successful print. Photon VS FDM comparison time. Resin is anycubic green with a gray primer, using settings from the spreadsheet for .02 layers. Model was tilted 45 degrees, with Auto support plus a few extra supports added for some overhangs. Getting some lines in the print not sure why, but it's negligible. Loving this quality.

翻譯年糕