hey guys whats up im new to this group just wanted to say hello and ask a few questions i have since this is my first 3D printer that uses resin. ive watched a few videos about leveling cure times and what are the best suggestions for slicing settings but i still have a few unanswered questions i hope you guys can help me with
:)
.
1.) I noticed in the manual that came with the anycubic photon that all of the slicer settings mentioned a range it didnt get a finite number i decided to split the difference with all of them. is this somehting ill need to change based on the print size or density?
2.) My first test print was a failure after releveling and printing a Die it came out great then after that i tried printing the flexi-Rex from thingiverse (see attached picture) and only the half of the print thats is below the red line printed the rest never stuck to the bed and just hardened in the bottom of the vat as a pancake.
3.) For now im cleaning with isopropyl alchol just agitating the print by submerging it in some and swirling it around then the same with water then setting it in the sun to dry is their anything else that i would need to do?
4.)Ive been looking at some primor to finish my prints with, is something like rustoleum brand spray paint can primor going to work or does it need to be UV resistant.
5.) ive found that its quite hard to get some failed prints off of the fep sheet at the bottom of the vat how should i go about removing these so i dont unintentionally damage it?
6.) Should i just use the supports that are sutogenerated and should i use light medium or heavy ive been using light but there seems to be some warping in areas
thanks again guys i really appreciate all the help and support ive yet to get a 100% succesful print but im confident that i will soon.
翻譯年糕
