Anycubic Photon Printer Owners 造訪社團

Well with Arturs help I have managed to get the face of my troopers back pack radio this far should have it done in the next week or so. (the back pack that is)

翻譯年糕

Question what’s the best resin to use for the anycubic prints

翻譯年糕

LATEST NEWS ON THE FTD RESINS FROM PEEDIE MODELS

NXT GEN FunToDo resin starts shipping

July sees a lot of excitement with the start of the NXT GEN resins being shipped this week from the factory:
Standard Blend - Red, Black and Clear
Castable Blend
Snow White*
Ash Grey - An exciting new product and as I tested some must say this is very clean with crisp detail.
* The NXT GEN Snow White has the same excellent quality for fine detail and low shrinkage rates, however when a finished print is removed from your printer it may have a slight yellow cast, but as it has a photo sensitive bleach the yellow cast will go during the post curing process, and you will be left with a very crisp white print.

With all the new blends you may require to make some slight changes to your exposure times, as this has been noticed on different printers and the enviroment you work in. So please can I ask for feedback when you start using them so I can add them to a database that I am building for this new range of blends.

You will see on the bottle the new logo NXT GEN clearly indicating the new version of resin.

翻譯年糕

Anycubic grey, shake or no shake? Is it worse not to be mixed, or to be full of bubbles?

翻譯年糕

So couple things in this latest print. I’m getting these stress cracks all over the surface. Fun To Do Industrial Black. They didn’t show up till after curing. Second I’ve got a few odd lines as well as the end curving up (this was the end closest to the start of the print at a 55 degree angle). I’m guessing more supports would help?

翻譯年糕

Preface: I am an associate and have bought my own Photon printer and want to just play around with it to get the hang of 3D printing.

What are the configurations of a decent Dell Laptop I should get. Trying to stay under 4 figures if possible.

TIA.

翻譯年糕

It’s done - one Photon ordered and on its way ! It’s done - one Photon ordered and on its way ! 翻譯年糕

Hey guys! I need help with the settings to use on the anycubic photon to print with industrial blend recin, any suggestions on how to do it is appreciated! Hey guys! I need help with the settings to use on the anycubic photon to print with industrial blend recin, any suggestions on how to do it is appreciated! 翻譯年糕

Heya guys new to the group and need some assistance i just updated my firmware and now im getting T_88 error code and the photon wont print anything and the detection shows no mask any assistance will be greatly appriciated thank you

翻譯年糕

functional prototype

翻譯年糕