Second attempt to print and instead of trying the full test print I switched resins and went with something much smaller and shorter in duration.
Resin: Nova3d Grey with the settings from the spreadsheet
Environment: about 73 degrees, night time with very minimal led light used to setup (my phone about 3 feet away facing away from the printer... More light came from the printer touch screen)
Result: The head and upper chest look nice, but the rest is a complete failure. See pictures, plus there was a small glob of cured resin stuck to the FEP, otherwise the resin was completely clear of cured resin. The print stuck to the bed as it was supposed to. This was supposed to be a halfling in thick robes on a circular base. I had it tipped back 60 degrees or so onto its back with light supports.
I am almost positive that the glob of resin on the FEP lined up with the bottom-center of the mini where the robes where supposed to be.
I am thinking that exposure time of 80 and 12 is too much, or too little... I feel like an old dog that cannot learn new tricks as I try to understand this exposure setting stuff.
翻譯年糕
