Anycubic Photon Printer Owners 造訪社團

Finally finished printing and assembling. If it gets painted I’ll try to share final pics but I don’t really know what happens to these things once I drop them off lol.

翻譯年糕

Hello,

I just wondering, how many ml of resin in bath do you need to start printing? For example, 50ml is enough? I haven't printer on desk so I can't measure that on my own.

翻譯年糕

I am having problems with one particular file. I've got 2 dog models that i have made and one of them printed perfectly the first time but I can't get the second one to print properly oven although they have the same body with the one printing only being slightly bigger.

The first print I got just 2 legs. The next 2 were stopped by the memory error code and another one has one leg missing and a section of it's body and the final one has all legs but is missing the front of it.

I am going to put the file through netfabb and 3dbuilder again to check for any errors and each time I've printed it I've increased the support material amount. Any ideas whats causing it. I do have bits stuck to the bottom of the vat each time which is making me consider chanign the angle i print it at to try and reduce the surface area.

翻譯年糕

is there something anti allergic for skin contact after painting?

翻譯年糕

Anyone has a file for the current "official" firmware 4.0.11_LCD Anyone has a file for the current "official" firmware 4.0.11_LCD 翻譯年糕

Anyone use XYZ Noble software? I've read good things about its AutoSupport. I used Meshmixer to hollow and B9 and native Photon for native support, but am curious about XYZ Noble.

翻譯年糕

Whipped up a custom resin color this morning, very satisfied with the outcome. layer time 12s. Printed on the ILUMI.

翻譯年糕

I’m not really sure how to read it. 5 or 6?

翻譯年糕

Does anyone have the firmware files for the photon? I was dealing with Anycubic CS and they gave me a firmware file that rendered my LCD inoperable... Hoping someone has older firmware I can try to get my printer back up and running.

翻譯年糕

After many long weeks of back and forths with anycubic I've finally recieved my replacement photon. It appears to be printing decently but I'm having an isssue where the bottom 1-2 mm is a little bit wider than the rest of the model. I printed 2 just to make sure it wasn't some random fluke.
I'm printing with monocure rapid white at the settings found on the spreadsheet.
I originally leveled using the Flint Reed method, but I've tried releveling just to make sure that isn't the issue.

翻譯年糕