Anycubic Photon Printer Owners 造訪社團

Concerning Fumes... My photon arrives today, and guests are coming tomorrow. Are the fumes/smell only noticeable when printing, or are they around any time resin is in the vat? The machine will live in the garage.

翻譯年糕

I was just in Microcenter in Columbus Ohio and they had 500ml bottles of monocure on sale for 15.97, normally 31.99. Seems cheap. Anything i should be checking for?

翻譯年糕

Anycubic just release two new videos on youtube, check it out.

ANYCUBIC Photon- The way to replace Photon 2k LCD screen
https://www.youtube.com/watch?v=Hvggm00agiQ

ANYCUBIC Photon--- Tension the FEP film
https://www.youtube.com/watch?v=Sdxf9mf7-ns

翻譯年糕

Something strange is on my photon, i have 8sec by layer but the projecting image is only 6 seconds x layer

翻譯年糕

alguien de México??

翻譯年糕

a question how do i prevent this from obstructions small holes arise from the support? And what's better, remove support immediately or later?

翻譯年糕

Hey all, is this Z banding? Looks a bit different than some of the photos I’ve seen. So just want to make sure before I do unnecessary work.
EDIT: .05 layer Monocure Gunmetal rapid using the corrected settings on the excel sheet.

翻譯年糕

Hey guys, thank you for the add. I got my printer about 2 weeks ago, but have been travelling a bit, so not much time to play with it. Anyway... I've tried a couple of prints that mostly worked. I've been trying to find a resin that has similar properties to TPU (for FDM), so a bit flexible and very tough. I'm making some camera supports for my racing drones and they take quite a few tumbles.
I used the Druckwedge Typ D Flex and the print shapes came out fine (with mostly stock settings), but the material was not so flexible and strong as well as being was brittle. So I tried the Photocentric Flexible UV Resin, which took a little tweaking of the settings to actually print (0.1mm, base 120s 8 layers, off time 4s, normal exposure time 23s). The print came out well but, even though it was a lot flexier than the Druckwedge, it was still not quite resistant enough to tearing. I'm trying the Photocentric Firm and Tough resins next week when I'm back home to see if they do the trick. Anyone has any recommendations for the tougher/stronger resins out there? Cheers!

翻譯年糕

I just got my photon the other day. I finally got the build plate leveled so that the print sticks to the build plate, but after it prints the raft, and starts to print the supports it fails. Any idea what I can do to fix this?

翻譯年糕

https://www.facebook.com/groups/AnycubicPhoton/permalink/1359047567573215/