Anycubic Photon Printer Owners 造訪社團

Hello everyone :) i need you expertise :)

If you were to have let's say 50 models lined up (all the same), and you need to quickly paint only a part of a model(* 50), and you have a very tight time span :D ,, how would you do it ? :D

what would you use to paint ? ... remember, you have 5 min. at the most per model for painting, and it has to look good :D

翻譯年糕

I saw someone here earlier this week mention layer thicknesses of around 44(?) micron (or fractions of). I've searched, but I can't seem to find the thread anymore. Would someone mind explaining which layer heights are optimal to use? I've got the newer photon without the thing that holds the big screw at the back at the top if that's relevant. Cheers!

翻譯年糕

hey all for those that are lazy as me or have the machine in another room i found a nice cheap solution to watch print progress from any pc or mobile phone:D its an IP Camera ID71 i had to refocus it because the autoexposure was not able to set exposure right but now it works :D

翻譯年糕

Monocure grey 0.04 / 10 / 1 / 60 / 5 ?

翻譯年糕

Just a reminder to take a break from printing occasionally, before you start dreaming about taking your Photon apart to find out the Z axis rod was bent.

Stop looking at me like that!

翻譯年糕

Bucktown...

I've been printing with it for over a week now. 20 prints...

I'm using the clear, but I print things that will be painted. That said, I have to recommend this as an inexpensive resin. It prints clean and crisp... better than the Wanhao clear (I use the same settings). It's cheap and does the job. $120 for 4 liters plus shipping. It isn't crystal clear, and has a yellow tinge... some prints look like an amber resin like in Jurassic Park, but if you are painting that shouldn't matter. If you are putting lights in, the LEDs should be bright enough to still make it look good. If you want a canopy or windshield... get Monocure.

This is good stuff.

翻譯年糕

Right, thank you everyone for the input. I’m going to buy the photon for the small detailed stuff and a Prusa for the terrain! Thanks all

翻譯年糕

I love going to bed and waking up to a new print :)

翻譯年糕

Yay............tired....too many screws LOL

翻譯年糕

Ok, so I had this on build plate and rest in form of blob at bottom of tank. Does it mean my supports were too small?

翻譯年糕