Anycubic Photon Printer Owners 造訪社團

What we have hee ...?

翻譯年糕

I need some help, my printer stoped working... I replaced the power adapter and releveled the z setting. 1st print after that was perfect. The next print failed, nothing on the bed nor on the fep film(??). After moving the z axes 30-40mm the motor started buzzing and the ax stoped moving. I can easily manually move the z ax (power disconnected) but the printer won’t move the ax and keep buzzing. I build some fdm printers and it sounds like the motor driver is having trouble, underpowered. Any idea where I should start looking before I tair out the main board??

翻譯年糕

Hello,

Just got a bottle of Fun To Do SB Black.
Did 3 test all went wrong.
1.) 0.03, 11, 1.5, 60, 8
2.) 0.04, 15, 1.5, 60, 8
3.) 0.05, 20, 6.5, 60, 8
At all 3 the prints only the bottom layers and the supports were print.
Did recalibrate the plate correctly.
Room temp 21 degree celcius.

Where does it go wrong?

(Anycubic Green resin several good prints with standard settings.)

Going to print this smal object again now in Anycubic Green.

Please advice. (y)

翻譯年糕

Just when your Photon can’t get any sexier.... red UV panels show up. Fit like a glove and in perfect condition. ?? Sascha Beez

翻譯年糕

What Primer are you guys using on your printed parts that works excellent and does not cost a ton of $$

翻譯年糕

Nova resin went up like 10 bucks on amazon!!

翻譯年糕

So...the Photon has this fan on the back. Which way is it supposed to move air. Mine sucks, and I'm trying to figure out what the air flow is supposed to be.

翻譯年糕

15% off coupon

翻譯年糕

Just a quick question guys. What happens if the power goes off in the middle of a print. Is there a resume option in photon ? If yes how effective is it? Does it leave layer lines or a gap or do the new layers even bond to the old ones?

翻譯年糕

Thank you Sascha Beez , can’t wait to install these red panels...

翻譯年糕