Anycubic Photon Printer Owners 造訪社團

Has anyone printed with a dental resin or is there a method I can use to make my print “food safe”? - I want to be able to put the print in my mouth and be certain that it is non-toxic

翻譯年糕

Has anyone figured out a way to prevent finished parts from getting hazy after cleanup? These parts are FTD IB Red. I washed them in 91% IPA, then in soapy water, then in plain water (edit: then cure for a few minutes with a UV lamp). Is there a way to keep the color looking rich and uniform?

翻譯年糕

So who do I contact about a new screen?

翻譯年糕

Hmmm

Didn’t get my monocure rapid clear working ? ?

Setting: 0.04, 10, 1,60,8

Bottom plate prints perfect, supports medium do not. And the model also not ?

Any experience?

翻譯年糕

So after cleaning the glass and screen with them seperated these Artifacts are still there. dead pixels?

翻譯年糕

does anyone know if we can print with flexible resin on the photon like form2? does anyone know if we can print with flexible resin on the photon like form2? 翻譯年糕

I have a set of these pigments for urethane casting. Does anyone know if they'll be compatible with our UV resins? I understand cure time could be affected by any pigment, but do you think it could "ruin" the resin completely?

翻譯年糕

Any reason a model I print is either above or below tolerance? IE: 12mm length on STL, 12.4mm / 11.6mm after print. My models have some wiggle room in dimensions, but not that much. (+/- 3.3% isn't tight enough tolerance fir 1/160 scale)

翻譯年糕

Supports seemed to be the issue. But now there’s a different issue. What causes these...voids? Near base of cape and in the book. Thanks!

翻譯年糕

Where is a good source for color additives for clear resin? I ask because I ordered 4 liters of the Bucktown clear. Even though I will be priming and painting all my printed pieces, clear can be pretty hard to see details for touch ups before curing.

翻譯年糕