管理員
統計數據
原文網址 Waldek Wasilewski 2018-05-21 03:41:22
Another great print
原文網址 Beulah Royds 2018-05-21 03:01:06
hey guys, we printed out a lithograph and we have washed it in IPA which had only been used for two prints before it, and then soap and water but it is still really sticky on the front. We've had it in the sun for ages, as well as a UV torch. What should we do?
原文網址 Laurentiu Neagu 2018-05-21 01:50:07
Just got an email from Photon, with two bin files to flash the firmware, one being the UI - anyone done that yet?
原文網址 Julio Fusè 2018-05-21 01:44:23
Do longer exposure times also increase the adhesion to the FEP?
原文網址 Phan Nhân 2018-05-21 01:25:17
Hi, I just found out my LCD has small crack on the glass after some failed leveling attempts, the printer is still working fine with good quality but I want to know if it is changeable by myself? Do I need to contact Anycubic for replacement?
原文網址 Karl Trout 2018-05-21 01:10:01
HERESY!!! I know I should be thrown out of this group for even suggesting it, but here it goes. Perhaps, just perhaps, we don’t need to wash our models in water nor post process cure them under UV lamps. What if, are settings are so that once cleaned with alcohol then air dried with compressed air there is no more “uncured” resin left on the model? For illustration can you tell which of these models went through a traditional post processing and which one was only clean and dried?
原文網址 Flint Read 2018-05-21 00:32:22
Made a thing. It's not on the Photon but is part of a project that will use the Photon :D
原文網址 Vinicius Silva 2018-05-21 00:24:11
Nice film, this means I found another way how sticking the exposure test to the plate fails.
Without the peel action we can't expose a new layer over :\
Back to the drawing board
原文網址 Phí Duy Quang 2018-05-20 23:32:59
Hi everyone ! It seems my Photon has a problem. Sometimes it stops working for no reason. I dont understand why. When that happens, the fan will turn off ,touch screen still works, but can not control anything ,it's just silent ( UV LED still hold the state from the moment it stops working ). I rebooted and it will be back to normal. Sometimes that happens when it printing and sometimes that happens when I'm calib the build plate. Has anyone encountered this problem ?
原文網址 Piotr Trębacz 2018-05-20 22:46:55
When upgraded photon is planned to be released? :) Will there be any discounts on childrens' day? :)
討論主題
發文排行榜
回文排行榜
熱門關鍵字