管理員
統計數據
原文網址 Julio Fusè 2018-05-19 00:44:16
After adding supports with the slicer the model no longer fits inside the printable area :( Is it possible to disable the supports right unter the model? the base is flat anyways
原文網址 Manuel Bradovent 2018-05-19 00:15:40
Anyone close to Slovenia and has larger build plate/bigger SLA or DLP printer? I need to print slightly larger print that photon has (cylinder 68mm, 125mm height) ?
原文網址 Manuel Bradovent 2018-05-19 00:13:09
Hi all. Which build plate settings you have in photon slicer? As per datasheet or more?
原文網址 何麥可 2018-05-19 00:06:04
Miniature 3D printed skulls painted.
原文網址 Joakim Schöldberg 2018-05-18 23:47:49
About the slicer, is there any way to trash a stl from the build area after you imported it? I use Mac version.
原文網址 Dominic Goff 2018-05-18 23:13:42
Ok so my first attempt at a print. Here are some watch cases I printed for my work. My phone can't display the details in the smaller case, you can see the brand name and logo clearly and they are tiny, quite amazing. It also has the holes for the strap pin and we can attach a real strap to it.
The larger one with the straps was flat on the bed and was tough to get off and has little rough white lines where I had to push against it to remove it. I'm very happy to have 2 prints and not a lumpy mess in the bottom of the vat :) This printer is at my work so I can't play anymore until Monday.
Printing watches has always been my excuse to get my company to fund my 3d printing habits :) Anycubic Gray is due in on Monday, tracking says its in Japan currently. Can't wait to start my next print. Thanks to this group for all the tips I've picked up over the last few weeks!
原文網址 Matt Paul 2018-05-18 22:51:55
Printer ordered! Looking forward to seeing how it compares to my Wanhao D7 when it arrives . Any suggestions for stuff I should have ready? Already looking at the replacement orange panels. Screen protector?
原文網址 Brian Carlsen 2018-05-18 22:40:07
Hi all, so I am still learning and have an issue I am trying to figure out. When do you use supports? Here is a print that has failed but I am not sure exactly why. Would supports fix this? I have tried supports with this before but the stupid raft that the base of the model sticks but the model itself falls off.
原文網址 Waldek Wasilewski 2018-05-18 22:12:07
Hmm weird fail print are deformed, missing drainholes?
原文網址 Jeff Frazier 2018-05-18 21:52:55
What is the solution for large flat bottom semi thin prints. To keep them from bending and bowing after the print is done.. More per layer cure time ?
討論主題
發文排行榜
回文排行榜
熱門關鍵字