Anycubic Photon Printer Owners 造訪社團

I'M A 3D ARTIST,CAN I BENEFIT FROM THE USE OF THE PHOTON? I'M A 3D ARTIST,CAN I BENEFIT FROM THE USE OF THE PHOTON? 翻譯年糕

Here we go with the first run! Witness success, or extreme failure! Lol!

翻譯年糕

Sorry no pics because i already removed the print off the plate. But what has happened is where the supports meets the piece it is badly distorted. Any ideas how to correct this?

翻譯年糕

Thank You. Just got my Photon in today, and could not wait to get it up and going and have my first print.

After being accepted (fairly recently) I sat back and soaked in what I could, read, watched, (with some drooling lol) and finally bit the bullet and got it off Amazon.

Though my USB stick came in blank, no lattice model :( , I was able to knock out my first print today. I'm happy to finally begin, with the resources shared in the group, and again thank you. To many more prints ahead ?

翻譯年糕

First (successful) print and I got a bit of wavyness and warping, should I increase the size of the supports of should I add more of them

翻譯年糕

Same Anycubic brand resin in white, 15 second exposure, 13 hour print time! ?

翻譯年糕

Hold on to your butts!

翻譯年糕

quien me puede decir las diferencias entre la wanhao d7 plus y la anycubic photon,en la calidad de la resolución y rapidez de impresión?

翻譯年糕

I am getting a large amount of the supports fusing to the bottom of the object I am printing - it is also causing warping of the part in the center of the object. I am thinking since the bottom of the object is flat, that I don't actually need any supports (with this model). Any idea on how I can optimize? Monocure clear rapid resin: .04,12,2,60,6 (as is in the google doc) with 6mm supports. Thanks!

翻譯年糕

Did someone say that there is a 4K version of the photon coming out?!
How would we make that happen ourselves? Pi 3 and what else would I need to do that??

翻譯年糕