Anycubic Photon Printer Owners 造訪社團

Fdm, dlp and dlp.

Wanhou white at recommended settings from the spreadsheet.

Print didnt finish on the larger dlp.

Will prime soon.

翻譯年糕

I know I bang on and on about it a lot, But, dear Photonster the best place to start in getting your prints to work is to level the plate and level it well.

It is quite literally THE foundation from which your whole print will hang. And if you do not get it right sooner or later your prints will start to fail.

So bear with me I will keep saying it for those new to our adventures in resin, And apologise for the repetition here and now.

Happy printing Photonsters may your prints be fast and your supports hold true.And may Photonia, gentle Goddess of resin printers insure your base never peels.

翻譯年糕

Good afternoon! We need your advice! Print these are the supports! Resin FDN! The model is hollow! Which location is optimal? Is it possible to print flat? The height of the layer is 0.09! What is the density of supports? 40% a lot or a little? Thank you in advance!

翻譯年糕

Lookign for alternatives to FTD (just want to see what else is good) What woud people say is better out of these thee... 3D-OKAY, Monocure, Druckwege ?

Cheers

翻譯年糕

Will it be ok as a replacement of the blamed PS?

翻譯年糕

Well it stopped printing for some reason. ?

翻譯年糕

FTD IB show for scale.

翻譯年糕

The less than canonical Klingon Runabout.

翻譯年糕

I even tried a big print for my first run. Main goal is the pipe, additional items were the towers and a calibration cube.
I sliced with anycubic, used monocure white and estimated time was about 20 hours.

After 14 hours the pipe looks good so far, the smallest tower is visible, but the rest is simply not there :-/ Hmmm.

What could cause that some object work fine, and some objects don't appear? Z-Level?

翻譯年糕

I did not expect I will run out of resin...

翻譯年糕