Anycubic Photon Printer Owners 造訪社團

Ok printed at a height of 43mm, the one on the left is the model Flint thickened up the Cape. The one on the right was the original model just scaled down. Thanks Flint.

翻譯年糕

How long do I have to wait to prime minis after printing it if they’ve been cleaned and cured under uv light, are they good to go?

翻譯年糕

What slicer do you use for this printer? Recommendation?

Is it the same as 3D printers using Slic3r on repetier? What slicer do you use for this printer? Recommendation?

Is it the same as 3D printers using Slic3r on repetier? 翻譯年糕

can someone tell me if my supports are good? 4 fails done before

翻譯年糕

So after a successful print of the photon cube. I tried a new print today. Carefully added loads of support and sliced it and started printing.

Nope nothing stuck to bed and stuck to FEP. So just cleaned it again.

If I got a good print last time that was well stuck to the bed why did it fail this time?

翻譯年糕

Here you see my first prints with my Photon printer using the green resin from Anycubic. I also did have some print failures.

翻譯年糕

So...here's the rsults of "breaking it down" tilting snd afding supports. A: those should be HEAVY supports, not medium as placed by anycubic. Everyone says TILT TILT TILT! This happens when I tilt. Suction force rips it off the supports. .05-11-1-120-8

翻譯年糕

And I have another question.
I noticed, that the vat is "sticking" on the screen below, after a print. Both parts were before printig cleaned with alcohol.
So it's clean but the adhesion is very strong.

How do you handle with that?

翻譯年糕