Thanks again to this group for the immense help and inspiring prints!
Thanks especially to Flint, Vaughan and Jeff for the help with my Monocure woes
(Monocure Rapid Gunmetal Grey)
Make sure it's around 70°F for optimal results!, This stuff is really thick otherwise and I think was creating a lot of suction.
After your guy's help I managed to get the very center working well but it seems like everything an inch diameter from the center is still having trouble sticking.
Has anyone else ran across this issue? I have been leveling and re leveling constantly. I have replaced the FEP film but still no luck. Made sure everything is clean as possible. Any feedback would be great! Most likely it is a noob mistake I am over looking. Haha
For reference it worked flawlessly out of the box until I had to change resin finally.
Thanks!!
翻譯年糕