管理員
統計數據
原文網址 Sebastian Fernandez 2018-04-16 22:06:10
Well, my Photon just died. The power brick just clicks Well, my Photon just died. The power brick just clicks 翻譯年糕
原文網址 Chad Elstad 2018-04-16 21:39:46
Ok, so first minor fail. Are the failed supports because I did not hollow, because I printed it very vertically to reduce supports, or because I didn't add enough supports? Some other issue? I dislike cleaning up supports so was trying to minimize them. Doing it this way, the build time was also like 6 hours.
原文網址 Mohammed Binamin 2018-04-16 20:45:26
Hi Does anyone use this printer for dental surgical guides / crowns and bridges / aligners etc.... ? How does it compare to other 3D printers - speed / cost / ease of use / software integration with dental software ? Thanks in advance.
原文網址 David Malagoni 2018-04-16 17:06:10
Hi all, after just a couple of amazing prints my new Photon stopped working. When I turn it on the red power led blinks uninterruptedly... should I give it back while I can? Is this a power supply failure?
原文網址 Seb Jägermetal 2018-04-16 17:00:45
Frozen dragon and awesome result! (Almost flawless)
原文網址 Phil Davidson 2018-04-16 14:22:19
how responsive have you found anycubic's support team to be? Waiting on word back re. my dead USB problem
原文網址 Antonio Quiquero 2018-04-16 12:51:16
Increased bottom exposure to 80...fail again (worst than 1st attempt). Trying 85 next.
原文網址 Vicente Adrian Lopez 2018-04-16 11:03:25
Current project. Still needs lots of cleaning and a bunch more parts still to print.
原文網址 Andy Levesque 2018-04-16 09:57:49
Is it bad to let a finished print sit in the printer for 6-8 hours before removing it?
原文網址 Antonio Quiquero 2018-04-16 09:20:01
New to this. Trying a castable resin (senertek cast). Find the copings in the vat 3/4 printed. Resin is a bit flexible . Is bottom layer too thin?? Parameters I’ve used are layer 0.025, exposure 10, off 2, bottom exposure 60, bottom layers 8. Should I increase bottom thickness and also normal exposure time?? Thank you. This is only my second print and the first one with this resin.
討論主題
發文排行榜
回文排行榜
熱門關鍵字