Anycubic Photon Printer Owners 造訪社團

Ok so I need to add a bit of resin to finish a print but it still has blue in it. This is a water elemental anyway so can I add clear and mix them? I assume it would just be a lighter blue and ok? Both monocure.

翻譯年糕

I have set up a Monocure 3D users group. Please join us! https://www.facebook.com/groups/monocure3d/

翻譯年糕

Hello everyone :)
Today I received my first Anycubic Pothon DLP printer. I have successfully printed nice small and high-quality parts. I have one issue though, the XY sizing is slightly off. Holes are too small and outside diameter to big. Is there any way to adjust the XY compensation for this printer? Can I use another Slicer software? And what software should I use? What cure times do you guys use? I have atm first 6layer 50sec and then 8sec/layer.

翻譯年糕

Popped my 3D printing ? on the Amerilabs city. Thanks to everyone in this group, especially Flint Read for the guidance!

翻譯年糕

So after every print, success or not, I will have sometimes very large pieces of cured resin floating around. Is there a way to combat this or is it an inevitability?

翻譯年糕

Tighten the wheel in the z-axis they said ...
At the beginning in my prints you could see really a little little bit of z wobble, now... well the picture speaks for itself... I'll go to loosen the wheel

翻譯年糕

Uhh... I don't recall ordering a jet engine lol... but in other news this should suck out all the resin fumes in the printer as well as fart fumes hahaha.

翻譯年糕

I finally got the time to try my first print last night, and it was a horrible failure :) I tried printing the Monocure Test Disc ( http://www.monocure3d.com.au/category-s/137.htm ). The result was nothing on the build plate and a thin disc stuck to the bottom of the vat (just a few layers; not like the whole object). My first assumption is that my leveling is bad and I need to re-level the printer, but could it be a suction issue? I.e.; should I try to elevate/angle it with supports? (I'll probably re-level regardless; leveling the Photon is definitely less of a pain than manually leveling an FDM printer :) ). Thanks!

翻譯年糕

Guys I did a small experiment with Transparency sheet today.
I added some C thru (Rain X)to one half of the Transparency. Then some resin to the CThru part and some to other part of the Transparency.
After curing the resin, it came off easily on C Thru / (RainX)side and the other resin stuck fast.
So just before my FEP needs to be changed I try it.
Also done what another Photonsters advised, add a piece to the screen.

翻譯年糕

Coming together slowly, He is gonna be a big lad when he is done.

翻譯年糕