Anycubic Photon Printer Owners 造訪社團

I hope I'm not the only one ....

....to notice that the Anycubic Slicer upgrade to 1.3.5 (new features for supports) ^^

;-)

翻譯年糕

Ok, so how do you guys decide when to change the FEP?
I really have no clue - it looks "used" after one print already!

翻譯年糕

Hi from Munich / Bavaria. I received my Photon last week. Made a couple of prints with the green resin that came with it, all turned out fine. I purchased additional black resin from Anycubic, here not one single print sticks to the platform. A intermediate print with green resin again went fine, so the platform is leveled ok. Any clue whats the problem? Thx for you help.

翻譯年糕

Very first print on the photon... i just went in head first, threw the file in 3d builder, hollowed it out, made 2 drain holes then sliced it using default setting...

Aside from the tail somewhat separating... it came out okay. If it weren't from the supports leaving marks lol. Now to learn some good settings for this printer...

I did a bad job taking off the supports cause i was in a rush to get ready for work at the same time lol.

翻譯年糕

Guys made a cover for my Vat. I would not mind doing a better one but this will do for now.

翻譯年糕

Has anyone got any experience using SLA resins with the photon or any other DLP printer? What settings did you have to adjust?

翻譯年糕

Also can anyone suggest a tough resin? I need some tougher resins for some items Im working on.

翻譯年糕

Thanks for the input yesterday everyone. Ordered some Monocure Blue.

翻譯年糕

Well I took the plunge and ordered one of these after a week of agonizing over the decision to buy it. It will be here next week along with 1L of Wanhao yellow resin that I got pretty cheap. Tips, tricks, and suggestions appreciated.

翻譯年糕

Any Anycubic staff here? Any Anycubic staff here? 翻譯年糕