Anycubic Photon Printer Owners 造訪社團

Question! I have been having problems with larger prints since I switched from the sample resin to monocure rapid clear. A lot of supports are failing to print entirely, which almost seems like a slicing error. Also, today there was a big slice through some wings I was printing that just cut out across the print. Any idea what would cause something like that?

翻譯年糕

hollow barrel with hole 2

翻譯年糕

This is seriously the best and most supportive group I have joined in a long time. Thank you guys for all the help and support.

翻譯年糕

Another mini print, mini Batman!!! 1cm height, about 7mm width. :D

0.020mm, 7.5, 1.5, 40, 8. Green resin sample.

File: https://www.myminifactory.com/…/3d-print-batman-arkham-asyl…

Yo soy (mini) Batman!!! La cabeza mide uno 6mm aprox. y se notan hasta los labios!!!!

Muy contento con esta maquina :3

翻譯年糕

My Photon arrived today. I started the test cube supplied on the USB stick and stopped it ~10% of the way through just to confirm everything was sticking properly. The print was well adhered to the bed and everything looked great. I cleaned off the build plate, started it again and am letting it run to completion now. Fingers crossed ?

I am going to have to pull out my 2K LCD screen because there appears to be some debris stuck to the back side. Well, at least it won't clean off from the front so I'm hoping it's on the back. There's also some debris trapped under the touch screen overlay on my front LCD but it doesn't keep the printer from functioning.

翻譯年糕

think a few of us can relate to this.

翻譯年糕

Hollow barrel with hole

翻譯年糕

Let's see, I will test you according to what printer has printed the ring and what resolution?

翻譯年糕

First attempt with monocure failed. Stuck to the fep. Time to increase layer times...

翻譯年糕