First i wanted to thank
Flint Read
for these tips.
1. once you have it unboxed Check all the little nuts around the USB ports are good and tight (I actually had one loose and this was a problem) You can solve this by gently putting a usb stick in the hole and using it to hold the port in place while you tighten the nut that is loose.
While you're at it turn the resin vat over see those screws in there? make sure they are nice and tight too if they are loose then your first print could ruin your FEP film by stretching it out of shape. A few screws could be tighten just a little bit.
Note
My resin vat screws all needed to be tightened a good amount. This could have been a huge issue.
2. check all nuts on the machine bed (the big flat red bit), Are all nice and tight too.
Note
A few screws could be tighten just a little bit.
翻譯年糕