Anycubic Photon Printer Owners 造訪社團

Guys may I ask this question here. In Meshmixer I want to do a plain cut but when I move the plain with mouse I am unable to move in small increments. It jumps to next level. Thanks

翻譯年糕

Hi guys
Since thursday my Anycubic printer is OOO :-(
After un dozen of succesfull print, I was planning calibrate Nextdent SG resin using Philippe Maegerman test print and advices (many thanks to him).
During my third print (12 minutes flat print with nothing special) I came back finding the printer 'off' the printing plate was at z=0 nearly, blocked at that heigth and LCP front panel black; I removed together the VAT and the plate horizontally (I was very worried to leave the VAT full of resin all days in contact with the LCD ^^).
I try to switch on/off several times, nothing happen.
When I switch 'on' I can hear inside the printer a 'tick-tick' clicking (like two clicks per second), I open the rear panel and saw a red led lighting on the left side at the same pace of the 'tick tick'.

Since I PM Alice Yu to obtain advices, for the moment no response.
Are some people here who had problems like this one, or who have mail of technician from Anycubic to help me solving that situation.
I own my printer for 10 days and I'm a bit disapointed, as you imagine.
Thanks for any help ;-)

翻譯年糕

hey guys, using the anycubic green resin, it seems to change to a white frosty look after cure on some parts, is it just too much UV?

翻譯年糕

Very first test print after fixing the initial problems. Looks good to me :)

翻譯年糕

Thanks to all Friend of the group, today I've tested the Funtodo WHITE resin with my Photon.

Parameters:
8leyer/bottom, 0.05mm/layer, 12Sec,2sec pause,50 sec bottom.

Now i've to remove the supports, any suggestions ?
I think also that may be a little overexposure.

I accept any other suggestion for the prints. Thanks to all.

Enrico.

翻譯年糕

Hello PhotonGuys! Some one spoke about B9... I never used it before... someone is able to give me hwhat kind of parameters to insert to be able to set it for the Photon? I will attach the main parameters window...

翻譯年糕

What kind of IPA containers do you use to wash the excess resin? Also, do you always change the IPA or just seal the container to be used again?

翻譯年糕

Hey guys, could you help diagnose what the likely problem is when my prints stick to the vat rather than to the upper platform? I tried the Anycubic test cube three times and never did anything stay on the moving platform, there's always just a thin cured layer attached to the bottom of the vat. I tried 1) redoing the z-axis calibration, but the paper is nicely snug like in the video and 2) clean the platform using ethanol (I'll get IPA shipped next week) and still no success. Should I try sanding it? Many thanks.

翻譯年糕

Tried to print this 3 times in FDM and failed. 1 time in resin printer, success!
+1 for resin. ?

翻譯年糕

What temperatures in centigrade or fahrenheit do you prefer to print at? Im running into issues are a room thats 65f or less..

翻譯年糕