Anycubic Photon Printer Owners 造訪社團

https://www.facebook.com/anycubic3dprinter/posts/346541632418632

Hello everyone ! I would like to test the grey monocure resin, someone have monocure settings for the anycubic slicer ?

翻譯年糕

I’m pretty new to the FB group thing. Traditionally I use forums for this type of knowledge sharing. Is there an effective way to filter the conversations? IE. I want to know what resins people are having the most success with? I’m sure this is discussed in the chat just curious how to best locate those discussions? Thank you for any advice!

翻譯年糕

Sword stand

翻譯年糕

Hello, I share my first impression, delighted with the details.
Height: 30 mm
Best regards

翻譯年糕

taking a 30 minute break from printing and painting for hobby #52, charcuterie! picked up a great pork belly today, curing it for some bacon mmm

翻譯年糕

Well... 4 out of 6 isnt bad. Still not complaining. This was mainly a test (2 different models 3 times). The only warping I see is from the one that was at 45° (maybe should have done 35°). All in all, I think the ultimate winners are the ones on the right. They were just lifted and loaded up with supports (3 times the support (heavy) on each corner)). The ones on the very left were flat on the build plate with no supports.

翻譯年糕

Its probably been asked before ...
how do you calculate how much resin will a print use ? Its probably been asked before ...
how do you calculate how much resin will a print use ? 翻譯年糕

this was your print of the Hero Forge design Karl

翻譯年糕

Bammm 1000 members ? ? ?

翻譯年糕