Ok, so either there is something wrong with the file i am trying to print from, or Hogwarts is out to kill my LCD. I made another attempt at the Hogwarts model that i messed up on previously. Only this time i hollowed it in Meshmixer, and reduced the size by about 25%. I printed it upside down from supports to give clearance for the drain holes on the bottom, and require no support for the tiny buildings.
I got the same result as before when i thought the model had peeled away. I caught it earlier in the print this time, but i do have a visible "bubble" on the LCD now. It does not appear to have caused any actual damage as the test patern is still clean.
I just found it odd that both sizes, one solid and one hollow, one flat on the plate and one on supports, resulted in the same print failure including tweaking the build plate.
The photos show the models oriented the same direction so the smaller one was a repeat of the results from the larger one. I'm curious what you guys think may be the issue.
翻譯年糕