Anycubic Photon Printer Owners 造訪社團

I redo the orange vs blue experiment using Normal LED torch light since that household light source is the one we want to block from entering the printer chamber.

So here is the result, I exposed it about 30s under orange panel & 20s under blue panel.

Hopefully it is useful for those who plan to modified his printer ?

翻譯年糕

Anyone else had it where the grub screw for the build plate no longer holds the build plate solid when tightened?

翻譯年糕

#3

Anycubic Photon Resin Sellers - 2nd Outline

翻譯年糕

Happy with the results base is a little messed up on the back but I'm ok with that

翻譯年糕

https://www.thingiverse.com/thing:2272157
https://www.thingiverse.com/thing:2471344

These prints turned out to be very useful. They were meant for the Duplicator 7 but the vat size is similar, if not the same for the Photon. Though for the vat cover I'll probably clean it up a little and add a layer of Kapton tape just to make sure it fully blocks any UV that might come through.

翻譯年糕

Sorry, mistakenly deleted my post. I'm thinking a braket to allow this method also with bigger prints

翻譯年糕

Well there photonsters, here it is, after 12+ days of continuous printing a few set backs and a day or two without resin, my chess set is done printing. Time to finish the detailing.

翻譯年糕

tried something larger and hollowed...

翻譯年糕

Relaying info from D7 group ;)

FEPshop will be closed from march 20th till april 9th.
March 19th is the last day you can place your order and have it shipped to you before we close!

翻譯年糕