Hello, i need your help. Today I received the printer Anycubic Photon and I started to set it following the instructions in the manual. I made the plate zero and I noticed that when it goes up and down it makes a noise of friction, in some places moving in jerky. The first thing that I verified was if there was lubrication on the guides and on the screw, in fact they were dry as I imagined, indeed passing a cloth on the guides they left a metal powder. I greased guides and screw and the scratching disappeared. Looking carefully at the plate as it moves, you notice a slight sway, wobbling I guess. On page 4 of the manual it seems to me that in the photo the upper part of the screw turns on a bearing, but in my printer there is any bearing, are yours also made like this? Then I switched to the function "detection" to check the operation of the display, unfortunately I think there is some problem in the display since it does not display a clean rectangular image, but as you can see from the picture there are a couple of dark horizontal lines, as if there were lines of dull pixels. I ask you to kindly give me suggestions as if it is a malfunction, I immediately return the printer. Thanks to those who answer me.
翻譯年糕