I'm excited to get started printing. Our first attempt in printing the Anycubic Logo Lattice Cube failed to adhere to the build plat. After re-leveling with the vat in-place we where able to print it with success.
I do have a few quick questions:
1) Do I need to re-level after every print? Does the aluminum mounting system for the build plate shift as you remove and reattach? Looks like there was a lot of thought put into keeping it centered and in the same place.
2) Are there known hot spots for the display area? I know on sets of Wanhao DP-7 I have access to all have hot spots in the back left.
3) I assume you should move move prints around the printing area to even out the use of the vat clear surface. We often do this with our Wanhao DP-7 and Form-1 vat.
4) Has anyone tried using a Wanhao DP-7 vat? they almost look the same except for the drain spout and the DP-7's post holes.
4) Any suggested maintenance and cleaning procedures? The Wanhao gets cleaned after every 10 or so prints. And after a few months we clean off the screw and reapply a fresh coat of PTFE grease.
Thanks again for any help or suggestions.
翻譯年糕