I have some questions about UV curing. I bought a strip of 5050 395-405nm LEDs. Most of what I'll be printing are small miniatures for tabletop gaming. So it can be a relatively small box. 25-28mm scale miniatures, so I assumed they would be too fragile to hollow; printed filled.
1. How do you determine undercured, perfectly fully cured, vs. over-cured?
2. How do you determine how long to cure? I don't see recommended cure times from all resin manufacturers, so how can you tell when something is fully cured and not overcured? While I understand cure times will vary whether it's filled or hollow, I'd like a better understanding of it.
3. Number of LEDs/intensity vs duration? What's the correlation between UV intensity and cure-time? Would it be better to have a dimmer on the LED strip to have more LEDs at lower intensity and longer cure time?
翻譯年糕
Daniel Ignacio Perez
2018-03-10 11:25:33
Greg Young
2018-03-10 12:18:50
Say Andrea
2018-03-10 12:32:36
Flint Read
2018-03-10 12:34:07
Flint Read
2018-03-10 12:34:40
Greg Young
2018-03-10 13:12:52
Anthony Cuttitta Jr.
2018-03-10 13:20:37
Flint Read
2018-03-10 13:22:56
Gareth R Thomas
2018-03-10 18:12:47
Simon Weil
2018-03-10 18:20:02
Gareth R Thomas
2018-03-10 18:20:58