Just finished replacing the fans on my Photon. Getting access is a bit of a nuisance - make sure you take the time to strip the machine properly if you are doing it, don't waste time trying to work around the touchpad, light tunnel and mainboard etc - just disconnect the ribbon cables where appropriate.
For reference, I have replaced the 5cm chamber fan and 6cm underside fan with a pair of 12V Gelint Silents (a 5 and a 6). These are 3 wire PC fans, but you just wire in the positive and negatives as per the stock fans and ignore the control wire.
This has made my anycubic massively quieter when running
:)
The fans are running full speed when on, so some more noise reduction could be achieved with an inline resister I reckon - at the cost of air flow. (I haven't bothered).
One thing to watch out for - the underside fan only spins when the UV lights are running - I was worried I had a dud fan or had miswired it until I realised this
:)
If you go for the Gelints, you either need longer screws or need to leave the fan guard off for the chamber fan. The underside fan fits fine btw (for those concerned with the width of it fouling on the heatsink).
翻譯年糕