Anycubic Photon Printer Owners 造訪社團

原文網址 Mario Kaufmann
2018-03-04 05:31:01

Hi, first post here. I just got a bunch of photocentric resins and I’m in the middle of testing them. So far my first tries were with the flexible clear one. Where should I report? Here or PM so it will be in the doc file?

翻譯年糕

原文網址 Justin Wunderlich
2018-03-04 02:30:19

Has anyone ordered through this site? Seems interesting vor me, because they have a german warehouse. :)

翻譯年糕

原文網址 Paul Manwaring
2018-03-04 02:24:16

Whats the deal with resins with the Photon. Ideally i'm looking for stuff that is strong and can be used for mechanical parts.

Any 3rd party resin suggestions?

翻譯年糕

原文網址 Artur Fuste
2018-03-03 19:41:52

Anycubic Photon Best Resin Settings Table updated with 6 new entries from ‎ Philippe Maegerman and Michel Mas .
Thank you all.

翻譯年糕

原文網址 Andrea Caudo
2018-03-03 18:54:08

Hi guys... im still having the "half display off" issue, also after repluging the ribbon cable... if i turn off and on the printer it usually works, but in some prints the "half display off" issue came also during the prints (first layer ok then display off)... so i emailed the anycubic again and the sent me a new firmware cause it may be a software issue... this is the email and the firmware files.... im trying the upgrade now...

翻譯年糕

原文網址 Joseph Anderson
2018-03-03 18:11:49

Does the blue tinted glass sides block UV light from entering the printing?

翻譯年糕

原文網址 Grant Parkes
2018-03-03 16:28:41

Hi all, after reading through the group the last day or two, I jumped and now awaiting DHL and South Africa customs, to come to the party a get it here quick!
If there are any other South African members out there, would love to chat as to where to buy supplies locally.
I think this little printer is going to complement my Anycubic Delta+ nicely ?? ??

翻譯年糕

原文網址 Philippe Maegerman
2018-03-03 16:12:09

Two amazing models from
https://gumroad.com/duncanlouca
28mm and 50mm Monocure rapid clear .04 / 12 / 2 / 60 /6

翻譯年糕

原文網址 Lauri Eno
2018-03-03 15:34:29

Hello. I am replacing my old b9 creator 1.1 printer. Have anyone tested b9 creator resins on this printer? Have u guys been happy about the z-screw nut? Is it bronze and are there any backlash? How about the linear guide? Is it rigid?

翻譯年糕

原文網址 Med Roland
2018-03-03 15:27:10