Anycubic Photon Printer Owners 造訪社團

I tried the anycubics stock green resin but i cant see any green color

翻譯年糕

New to DLP and recently got a photon: first test failed (think the build plate was 0.1mm too high) *leveled bed again*... second and third prints came out amazingly without re leveling or doing anything other than cleaning with alcohol in-between...4th failed (was peeling off the build plate)...so I re leveled and it still failed again in the same way...
Any ways to ensure better bed adhesion?
Should you need to re level the bed?

翻譯年糕

Any suggestion for castable resin for anycubic photon from china?

翻譯年糕

Bleh. First failed print on my Photon using 3D Okay Grey resin. All of the test sheets came out fine-- went to print model. Sticks to FEP sheet.

Doh.

翻譯年糕

Need legitimate places to buy a Photon. AliExpress is out, GearBest pre-orders are closed.

Right as I made enough to allow this, it's out of stock.

There's a few posts asking about individual stores, but I'm looking for any reputable store that has it in stock or preorder.

翻譯年糕

Has anyone ordered from 3DPrintersBay? I ordered my printer at the start of last month but haven’t received it yet. I know it was Chinese New Year, and they sent me a DHL tracking number recently that doesn’t work (non-existent) and don’t reply to messages and not possible to reach via phone (just goes to a voicemail).

翻譯年糕

I have a lot of experience with FDM, and am aware of the "magic numbers" - i.e. the z layer heights that correspond to the stepping of the z-motor combined with the pitch of the z-screw. On many FDM's, this works out as an "ideal" layer height of 0.04375 mm, and multiples thereof.

Has anyone looked into the magic numbers for the anycubic? It could help z accuracy and quality
a lot.

翻譯年糕

Did someone print with the Green Anycubic Resin at 0.03 Layer height and can tell me good settings? With 10sec the print isn't good. On 0.05 it is perfect. But I need to print the model in 0.03 for max details.

翻譯年糕

Please someone try this and report back :)

翻譯年糕

Thinking about changing the led to a 30w in hopes of lowering cure time. Anybody done this??

翻譯年糕