Anycubic Photon Printer Owners 造訪社團

原文網址 Artur Fuste
2018-03-02 02:20:28

FunToDo Standard Red, first tests.
All with same settings, 0.04, XX, 2, 50, 8. Only changed exposure time.
I like more 12sec. All the parts are still flaccid after 4 minutes external UV.
13s and 14s after same time as 12s in IPA bath are sticky, very sticky...

翻譯年糕

原文網址 Philippe Maegerman
2018-03-02 00:07:31

So after replacing the FEP sheet I had two failed attempts at printing .... was a bit scared I did something wrong as the sheet is pretty tight ... decided to print these guys once again, they are easy and no supports, and good surprise when back home ;)
Monocure rapid clear 0.04 / 12 / 1 / 60 / 6
The magic is still in the air

翻譯年糕

原文網址 Daniel Dulitzky
2018-03-01 21:58:40

good morning everyone
so its time to buy more resin
looking at the table , fun to do black and monocure black have the least amount of normal exposure time
are they good though ?
and is there any way to add some sort of rating system to the table ?

翻譯年糕

原文網址 Justin Berry
2018-03-01 21:31:25

You can see the little seats in the cockpit!!!

翻譯年糕

原文網址 Justin Berry
2018-03-01 21:20:41

原文網址 Justin Berry
2018-03-01 20:59:03

Waiting patiently for this palm sized millennium falcon to finish. 99%!!!! That last 1% seems like a life time!!

翻譯年糕

原文網址 Milko Todorov
2018-03-01 17:35:18

for my first ever print with Monocure Rapid grey I got the settings of Philippe for 0.05 but the result was nothing on the build plate and barely anything on the vat :(
I ramped up the first layers to 80 and normal to 12 and this is the result.
You can clearly see that the support for the arm is correctly ending where the arm should start, but the arm is deformed at the elbow and got "shrunk" in it with distortion. There is also slight issue with the cape, and there were few "peels" from overcooking
All supports added manually in meshmixer