管理員
統計數據
原文網址 Richard Groenendyk 2018-02-23 00:36:57
Has any one used a do I need to change any thing to use it
原文網址 Megan Pearce 2018-02-22 23:48:39
原文網址 Philippe Maegerman 2018-02-22 23:36:20
Primer one coat
原文網址 Ronny Raimondi 2018-02-22 21:47:02
Hi everyone, modular ring test ... 25 micron
原文網址 Artur Fuste 2018-02-22 20:54:15
These were the best settings i've found for Fun To Do Industrial Black. The piece will take 9 hours to print :-( Any of you have already success with 0.1mm layer and want to share?
原文網址 Philippe Maegerman 2018-02-22 20:09:19
Medium supports with medium tip in XYZ software are surprisingly easy to remove, you can just tear them away by hand if you want, they will leave some bits on the surface that you have to inspect and remove with the cutter. I prefer to trim them one at a time, takes time but the end result is just amazing. Now primer
原文網址 Philippe Maegerman 2018-02-22 18:43:35
Cleaning the baby, I had to raise my lamp to accommodate it :) Next remove supports
原文網址 Philippe Maegerman 2018-02-22 18:01:54
Fresh out of the box ;) My biggest print so far.
This is the model : https://www.thingiverse.com/thing:1581416
And if you are interested, my STL ( 98Mb ) hollowed in Meshmixer and supports from XYZ Nobel software : https://drive.google.com/…/1JcVo7QMtcTjAEDu7xCSxJfiIE…/view…
原文網址 Philippe Maegerman 2018-02-22 16:52:24
90% :P
原文網址 Chance Reeves 2018-02-22 13:35:42
Before mine arrives, I have a question for someone who has theirs already... Will you open the lid and measure the distance from the table to the highest point when lid is open for me? I’m just trying to decide where I’m going to place mine.
討論主題
發文排行榜
回文排行榜
熱門關鍵字