Hey guys in really struggling to get this print to come out nice. It keeps disconnecting from the supports. And warping. But the end of the print turns out fine with high detail. I am printing 12 bottom layers at 100 seconds. And I am printing 12 seconds a layer.
翻譯年糕
Mongo Rogers
2020-03-27 06:12:54
The bottom layers and 100 second seem like overkill. Maybe try dropping that to 6 at 60 seconds and 12 second exposure is way too much. Will kill your detail. Drop to 7a and try there.
And I am not an orientation expert by any means but I would give those bad boys a 45 degree tilt with bottom side down
Thomas McConnell
2020-03-27 06:24:06
Mongo Rogers
2020-03-27 06:24:51
Thomas McConnell
2020-03-27 06:48:45
Scott Pavlich
2020-03-27 07:02:09
What resin? Layer height? And are those medium supports?
Thomas McConnell
2020-03-27 07:15:14
Light supports I figured it was probably the supports themselves
Mongo Rogers
2020-03-27 07:25:20
Hmmm. Ok that makes it harder. Can you post your slice?
Thomas McConnell
2020-03-27 07:25:59
Thomas McConnell
2020-03-27 07:26:11
Thomas McConnell
2020-03-27 07:26:15
Revin Leong
2020-03-27 17:51:10
Try using large supports.
