Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Halp pls!
My control touchscreen is suddenly reading in the wrong spot.
For example 'Print' can now be pressed from below where 'System' is on the menu.
System can now be pressed way down the bottom below tools at the very edge of the screen.
And of course tools cant be pressed at all since its now off screen.
Same for all the other menus, everything has shifted majorly downwards.

Thought I may have resin on the screen but gave it a major clean and its perfect with no signs of contamination.
What the....I swear its not possessed by the chaos stuff I printed...

翻譯年糕

*Update for anyone searching for similar priblem in future. It was thr file. I must have missed a step repairing the file when i put it back together. Damn noob!

File or USB? Seems like it's made the supports into a giant solid mass (was only minimal manual added supported print)
Haven't run into this issue before so want to fix the right thing first!
On the brightish side...best adhesion ever lol

翻譯年糕

Am I pushing my luck with this one? (Supports/build area/settings)
It has awesome tiny detail thus the .02 / 11 / 1 / 100 / 8
Monocure rapid black since I have been getting good results with other BFG stuff in single piece but not battle barge sized.

翻譯年糕

First time replacing LCD help pls!

Do I need to remove that back layer (or any other layers?) on the new screen before installing?
Seems seperated and is a solid silver color back....slightly different to the old one I just removed.
Supposed to be like that?

翻譯年糕

New one (to me at least)
Getting a lot of what appears to be overcuring? Extra curing of resin on prints.
Its also leaving a hard solid piece on bottom of vat.
But the prints are normally still good with no loss of detail.

What setting or setup am i stuffing up? Its wasting a lot of extra resin and clean up sucks!

翻譯年糕

First try of this big fella on the photon.
Three prints, then assembly.

I failed a few supports on the end of the barrels, but I think the overall effect is pretty nice!

*all credit to the original designer of this. I was so excited when this was uploaded!

翻譯年糕

Hi everyone,
Prints are 90% great, but'melting/running' look in parts and lose of some details on build plate side.
Have just switched to monocure rapid grey from the cubic green.
.025 layer exp 12 off 1 bottom 110 bottom layer 5
(The minis are only 22mm long)
What setting am I getting wrong for this?

翻譯年糕

Evening all, does this defiantly require a change?
First time had a failure really stick to the bottom. Probably worse in pic than person due to size but im 50/50 as havent had to change before.
Appreciate your advice!

翻譯年糕

Hi guys, just took delivery and ready to set up.
Is it too dusty in the average garage to print from?

I have a real good space there but am worried about the dust levels contamination.

翻譯年糕