Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Finnaly got around to cleaning my printer and tried to fix a few things, but I think I made it worse. 3 wires were cut when moving the bottom plate out. Any ideas on where I can get a replacement cable?
Thx all!

翻譯年糕

Sooo not sure why sti. But vat got stuck to the screen, and stupid me think the screen was more secure then it was, popped off the screen. Along with the ribbon cable. Soo the ribbon cable is unplugged from screen.. The cable seems ok. Buuut how do you plug the cable back in? Or is it impossible.

翻譯年糕

After some discussion on led power and size, made another cure box using same idea with solo panels (inside the lid) for turning a display plate. Sorry for the blinding light, it is 24 watt leds

翻譯年糕

aaaa! my last FEP sheet had a small slit in it and leaked! and now im out of sheets! anyone know of a place that sells these? also, take note when installing a new sheet, leave slack! when you bolt it down, it will tighten down more, i though i was ok, but then after 10 prints on it, i noticed it leaked.

翻譯年糕

Looking to building a enclosure, and pick up parts today, but forgot to get measurements, on the site it says, 220mm x 220mm x 400mm which is 8.66in x 8.66in x 15.78in (about 25in with the lid open) can someone confirm these are 100ish% accurate? Found some bins that were 15 in, amd afraid the . 78 would prevent the container to fully close.
Thanks everyone!

翻譯年糕

Pretty neat stuff going on, after my last post had a discussion on there and received the advice of using a solar powered turn table to spin while uv lights are on, and damn its spinning pretty good for only solar power. It's till has alot of work to be done and yes, cleaning lol, panels will be blacked out and painted with reflected paint anyways later. But, pretty neat idea

翻譯年糕

So did some shopping for some sort of uv cure station. Didn't find one I liked, so I built! Lantern for Michael's was like 20$ on sale

翻譯年糕

Figure I'd post my first with a print recently did, very impressived

翻譯年糕

Thank you for the acceptance! Getting my first dlp printer soon. Any tricks or "things you wished you knew before" items I should be aware about with this printer? Also what is a good place to buy more resin. Thank you guys?

翻譯年糕