Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hello,
I am looking for a high resolution mat finish resin for modeling. I have seen dentifix modeling resin and it looks ideal. Had any one used it in a photon? Or is there a better option?
I did try ameralabs but had major issues with any print with a large surface area.
Thanks

翻譯年糕

My memory stick that came with the printer has passed on, having problems finding one that works! Currently using an old 4gb drive - but I would like a spare. What are you lot using?
Thanks

翻譯年糕

Hello, got my printer working great now. Now I am looking into the best way to cure parts, currently just leaving them out in the sun. It's just not that reliable!! Ideally looking for something that will work with large parts as well. I have seen UV nail lamps mentioned before, just thinking that they are going to be too small and not powerful enough for the large prints - seen UV sterilisers that are big enough and low cost-effective would they work?

翻譯年糕

Hello, I have noticed a very strange issue when using my photon printer.
If It is left on overnight to complete a print then it will complete that print fine, but nothing else will stick until i change the resin (I have two bottles of the same resin, so i just swoped it over) then the printer will work fine and the prints stick to the bed and not the fep.
Is temputure playing a part here? living on the north east of scotland we dont get the high temps you would down south.
Or is the resin going bad? will try the resin again after this print completes.

翻譯年糕

Hello, do any other slicers produce printable files for the photon - except the supplied one?
Got my printer ordered and I am exploring my software options.
Thanks

翻譯年糕