Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I am looking to possibly add a HD button cam to the inside of my Photon for capturing time lapse video of prints. I have modified my glass with an extra UV protective one way film (mirrored looking) since I am printing in a sun lit area so I can't record from the outside of the printer.

I have been doing some research about lighting the inside of the printer with white LED lights and there is some indication that there would possibly be a tiny amount of UV. What I haven't been able to ascertain is would that bleed through UV even be in the 405nm vicinity to possibly risk premature curing? Does anyone have an idea how one might find that kind of information?

Worst case, I suppose I could purchase some white LEDs and run a test on the resin in a dark place?

Any insight would be much appreciated!

翻譯年糕

First print went well tonight. Just the test print but I was testing my ventilation setup which worked very well. What I ended up doing is venting from the top in a 4" duct. I replaced the upper window with a part from thingiverse and connected to a cheap 100 cfm fan through another 4" duct to a custom created window insert. I then flipped over the fan inside the photon to have it vent up into the build area to have proper air flow. It didn't move a lot of air with the length of the duct work but it was enough negative pressure to have no odor at all.

翻譯年糕

I am new to the group and have my Photon showing up in a few days and I am very excited!

I am looking to model a custom vent solution to allow me to pipe the exhaust to a window through a 4 inch pipe with an inline exhaust fan and would like to get this printed on my FDM printer before it arrives. Looking to make it work in a similar way to how a window AC unit fits so it can be removed and stored while not printing.

If anyone could give me the dimensions for the rear removable panel (length, width and depth) along with the distance the screw holes are from the edges I would be eternally grateful!

Thanks!

翻譯年糕